Dear Friends,
Anybody have idea about changing native vlan on Huawei MA5616 DSLAM?
I can not find the correct syntax, there is no option under "interface eth
0/0"
Thanks
It`s configurable under scu/scuh/giu board
interface scu 0/9
native-vlan 1 vlan XXXX
native-vlan 2 vlan YYYY
or
interface giu 0/19
native-vlan 1 vlan XXXX
native-vlan 2 vlan YYYY
Dear Georgi,
MA5616 does not have any SCU interface...
What can we do?
Only these interface's are available under:
MA5616(config)# interface ?
adsl
emu
eponnni
eth
gponnni
h248
loopback
meth
null
shl
vdsl
vlanif
Thanks
Dear Tina,
Thanks for your reply,
I have done the same example you told but there is no native-vlan command
inside interface eth 0/0.
here my configuration and version of device, maybe firmare does not support
it.
MA5616#display current-configuration
[vlan-config]
<vlan-config>
vlan 2 smart
port vlan 2 0/0 0
MA5616#display board 0
-------------------------------------------------------------------------
SlotID BoardName Status SubType0 SubType1 Online/Offline
-------------------------------------------------------------------------
0 H831CCUB Active_normal EP1A ASDA
1 H835ADLE Auto_find
2 H835ADLE Auto_find
3 H835ADLE Auto_find
4 H835ADLE Auto_find
5 H831PDIA Normal
-------------------------------------------------------------------------
MA5616#display version
Command:
display versionVERSION : MA5616V800R308C01
PATCH : SPC200 SPH508 HP2108
PRODUCT : MA5616Mainboard Running Area Information:
--------------------------------------------
Current Program Area : Area A
Current Data Area : Area AProgram Area A Version : MA5616V800R308C01
Program Area B Version : MA5616V800R308C01Data Area A Version : MA5616V800R308C01
Data Area B Version : MA5616V800R308C01
--------------------------------------------
MA5616(config)#interface eth 0/0
MA5616(config-if-eth-0/0)#?
---------------------------------------------
Command of eth Mode:
---------------------------------------------
auto-neg Enable/Disable port negotiation
combo-mode Switch working mode of COMBO port
display Display information
duplex Set duplex
flow-control Support flow control
line Line test
mdi Line-adaptive function
mirror Add mirror
network-role Network role
port Set TX optical power threshold
quit Exit from current mode and enter prior mode
reset Clear port statistics
return Enter the privileged mode
shutdown Deactivate port
speed Rate
switch Switch language mode
traffic-suppress Set port traffic suppression
undo Negate a command or set its defaults
Thanks
Dear Shahab,
Thank you for more information.
CCUB main board doesn’t support native-VLAN setting, only CCUE main board supports it, the version should be upgraded to R312 above.
Thank you,
Tina
Dear Tina,
How can I upgrade the version? main board must change or it can upgrade
with changing software/firmware?
Thank
Dear Shahab,
Thank you for your prompt reply.
You can change to CCUE main board, then check the version, as far as I know, the software on CCUE shipped are all R312 above, so u don't need to upgrade software.
Thank you,
Tina