A9K-MPA-20X1GE in ASR9001

Mailman List Mirror (Read Only)
1

Hey, anyone had issues with A9K-MPA-20X1GE in ASR9001?

It get disabled for us after 20 seconds finishing initialization, with
such message.

%PLATFORM-SCC-2-BAD_ID_HW : Failed Identification Test in 0/130/0 [1/0]
The module in 0/130/0 in this router may not be a genuineCisco product.

2

Hi Nikolay,

We're using them without problems. What software are you running? I did
have major issues with flapping onboard 10G ports disabling TX.

Regards,

Remco Bressers
Signet B.V.

3

Tried on shiped 4.3.1 and now on 4.3.2, with same results.
Also IIRC onboard ports only accept SFP+ rigth?

4

We use that combination without difficulty as well.

                -Bill

5

Have you tried a different IOS?

Ahad

6

So far only 4.3.2 and 4.3.1. Probably gonna check it on 4.2 tree and
more recent 5.1

7

We're running 4.2.3.

                                -Bill

8

So far only 4.3.2 and 4.3.1. Probably gonna check it on 4.2 tree

We're running 4.2.3.

Sorry for the multiple posts… We're also running 4.3.0 with the combination successfully.

router.nrt.woodynet.net:!Image: Boot Image: /disk0/asr9k-os-mbi-4.3.0/0x100000/mbiasr9k-rp.vm
router.nrt.woodynet.net:!Image: Boot Image: /disk0/asr9k-os-mbi-4.3.0/lc/mbiasr9k-lc.vm
router.jnb.woodynet.net:!Image: Boot Image: /disk0/asr9k-os-mbi-4.2.3/0x100000/mbiasr9k-rp.vm
router.jnb.woodynet.net:!Image: Boot Image: /disk0/asr9k-os-mbi-4.2.3/lc/mbiasr9k-lc.vm

We have this command on the interfaces as well:

transceiver permit pid all

…which was necessary to get it to support 1gb SFPs, in addition to the 10gb SFP+ transceivers.

                                -Bill

9

I feel should be the hardware issue.