Hi All,
I'm trying to bring up GigE link between 6509 and GSR.
This is my problem:
In the GigE interface on GSR says the interface is UP and line protocol
is UP and in the GigE interface on 6500 says "not connected".
Anyone have been in same situation?
/michael
set port neg X/Y dis
/Jesper
Jesper Skriver wrote:
>
> Hi All,
> I'm trying to bring up GigE link between 6509 and GSR.
> This is my problem:
> In the GigE interface on GSR says the interface is UP and line protocol
> is UP and in the GigE interface on 6500 says "not connected".
>
> Anyone have been in same situation?set port neg X/Y dis
"autoneg off" is default in WS-X6516-GBIC. I'm runnig OSR6500 and
WS-X6516-GBIC.
otherwise this is what i have done :
1. rebooted whole system several time and enabled and disable interface
several time.
2. tried with 3 different fiber and 4 different GigE GBIC SM LX, tried with
other equipment without any problem.
3. tried with different GSR and 6500, tried between 6500s with same GBIC and
fiber without any problem.
4. cleaned the fiberconnectors and the receiving input power(between -3dbm to
-19 dbm) is -6.3 dbm on both side.
The GBIC I have used is WS-G5486 on both side of the GigE link and I have
also tried also with GBIC from 3Com.
Hmm, the below works for me (on SX GBIC's)
interface GigabitEthernet4/0
no negotiation auto
set port negotiation 2/2 disable
router#sh diag 4
SLOT 4 (RP/LC 4 ): 1 Port Gigabit Ethernet
MAIN: type 43, 800-3955-03 rev A0 dev 994064
HW config: 0x00 SW key: 00-00-00
PCA: 73-3302-04 rev A0 ver 4
HW version 2.1 S/N CAB0436C1EC
MBUS: MBUS Agent (1) 73-2146-07 rev B0 dev 0
HW version 1.2 S/N CAB0429AVBW
Test hist: 0x00 RMA#: 00-00-00 RMA hist: 0x00
DIAG: Test count: 0x00000000 Test results: 0x00000000
L3 Engine: 1 - Standard OC48 (2.5 Gbps)
MBUS Agent Software version 01.43 (RAM) (ROM version is 01.33)
Using CAN Bus A
ROM Monitor version 10.00
Fabric Downloader version used 13.06 (ROM version is 13.06)
Primary clock is CSC 1
Board is analyzed
Board State is Line Card Enabled (IOS RUN )
Insertion time: 00:00:09 (17:17:00 ago)
DRAM size: 67108864 bytes
FrFab SDRAM size: 134217728 bytes, SDRAM pagesize: 8192 bytes
ToFab SDRAM size: 134217728 bytes, SDRAM pagesize: 8192 bytes
0 crashes since restart
And the module in the 6509 is WS-X6408-GBIC
/Jesper
Hi all,
Thank you all for the input.
I thought I had disabled autoneg but I didn't.
/michael
Jesper Skriver wrote:
I'm trying to bring up GigE link between 6509 and GSR.
[snip]
Anyone have been in same situation?
Several people were in early October 2000 on cisco-nsp See
http://puck.nether.net/lists/cisco-nsp/
and the thread titled, strangely enough, "GSR/Cat Gig-e problem". I'd
suggest you take your vendor-specif questions to vendor-specific fora.
Cheers,
Joe